At настоящее время, общий диаметр технические характеристики кольцо кольцо канавка заклепки на рынок 1.4, 1.6, 2, 2.5, 3, 3.5, 4, 5, 6, 8, 10, и т.д., клиенты может также выбирать согласие к к требования из механические свойства. кольцо заклепка и другое крепеж, должное к использование из разное места и использование из среда, часто требование спецификации есть разные% 2с много раз оно есть необходимо для настроить их собственных спецификаций. их обычное клепка тело длина спецификации 4, 6, 8, 10, 12 и так on. As far as as материал is concerned, кольцо паз заклепки воля также иметь алюминий, сталь, нержавеющая сталь сталь и материалы.
Ring groove rivets pay attention to point 1, if it is a rivet type ring groove riveting, then the power of the power part and the pulling head must meet the specifications and shape requirements of the rivet. Ring rivet Note point two, which is applicable to all rivet regulations, that is, at the beginning of the rivet, to push the pull gun head to the end and firmly pull the gun. Note point 3, after making holes, the sandwich thickness of the riveted parts must be tested with the sandwich thickness ruler to select the appropriate rivet length. Ring slot rivet point four, pull the rivet, if the nail head is not close to the component, it is not allowed to hit the nail head again. Ring rivet pay attention to point five, pull the riveting pull gun head to keep perpendicular to the surface of the workpiece, and apply enough pressure to make the nail sleeve stick to the workpiece. Ring slot rivet Note point six, ring slot rivet insert or drive into the hole action, must be light and steady. Ring groove screws must pay attention to the relevant installation matters in the installation, so as to avoid errors in the installation, and the service life in use will be brief, which is not responsible for their own installation and irresponsible to the customer. More details can consult China standard parts network.
